![]() What you have to do is hold the flash button down, start uploading and only release it when you see that it's started uploading. You can read more about how esptool works on their github page. These are some small tips that are beneficial for first time users of this software, and hopefully will make it more accessible and cause less headache when flashing the board. You can also find predefined config files for certain boards in the configs folder. ![]() ![]() You might want to adjust the display, LED and button configurations. You can also clone the project to get the latest changes, but you will also get the latest bugs. Download the source code for this project from the releases page. If it doesn't work, just try flashing it again and see the Installation tips and tricks.įirst you have to install and open the Arduino IDE. Select the COM port, go to config and select your. Another easy to use GUI flasher, but this time only for Windows: nodemcu-flasher. It helps you go through the process step by step and also provides the drivers you'll need. Espressif has an official GUI tool for Windows. Using the NodeMCU or any similar development boardthe flash location is 0x and the mode is dout. ![]() If you're beginner, have a look at Node2Deauther. Use one of the following software to flash your ESP with the. But all in all, it shouldn't matter that much. The 1 MB file should be good for most devices.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |